Model: 2/2-way direct acting solenoid valve

• High quality seal material
• Special versions up to +180ºC
• Impulse version optional
• Threaded port and sub-base connections
• Explosion proofed version optional

Technical data

Body material

 Type 6013                           Brass, stainless steel 1.4305

 Type 6013 A                         Brass, stainless steel 1.4305

Seal material                         FKM, PTFE/Graphite (EPDM on request)

Analysis version                      Silicon, oil and fat free version

Type 6013 A                          Tightness <10-4 mbar l/s

Limit value for risidual carbon 

Type 6013 A                          <0.2 mg/dm²

Medium                                  • Technical vacuum

Type 6013                                • Neutral gases and liquids

Type 6013 A                           (e.g. compressed air, water, hydraulic oil)

• Neutral medium, which does not attack the body

                                    and seal materials (see chemical resistance chart)

Media temperature

 FKM                               -10 to +100 °C (PA coil) till 120ºC (Epoxy coil)

 PTFE/Graphite                       Up to +180 ºC (see chemical resistance chart)

 FKM, Circuit function B                -10 to 100°C (AC) -10 to 120°C (DC)   

Ambient temperature                  Max. +55 °C

Viscosity Max. 21 mm²/s

Port connection

 Type 6013                          G1/8, G1/4, G3/8, sub-base

 Type 6013 A                         G1/8, G1/4

Operating voltage

 Type 6013                          24 V DC, 24 V/50 Hz, 230 V / 50 Hz

 Type 6013 A                        24 V DC, 230 V / 50 Hz (other voltages on request)

Voltage tolerance                     ± 10%

Duty cycle/single valve                   100% continuous rating

 With block assembly on manifold        Intermittent operation 60% (30 min) or with 5 W coil

on request

Electrical connection                     Tag connector acc. to DIN EN 175301-803 Form A

(previously DIN 43650) for cable plug Type 2508

Installation                            As required, preferably with actuator upright

Assembly                            No oils, fats or silicone to be used during installation

Protection class                        IP65 with Cable Plug

Coil insulation class                     Polyamide class B

Epoxy class H